Front Ground Support; Impeller; To Disassemble The Impeller; To Assemble The Impeller - Husqvarna K 535i Workshop Manual

Hide thumbs Also See for K 535i:

Table of Contents

7. Remove the screws and remove the cutter arm.

6.13 Front ground support

6.13.1 To replace the front ground support

1. Replace only the wear protection (A) or the complete

ground support (B).

Note: The impeller can be removed with the motor

attached or removed.

1. Disassemble the handle half. See

the handle half on page 10 .

2. Put a screwdriver between the motor and the

impeller to remove the impeller from the motor.

744 - 002 -

•

6.17.1 To remove the blade shaft bearings

1. Remove the cutting arm. Refer to

2. Remove the motor. Refer to

3. Put a pipe as support. Minimum inner diameter: 34

To disassemble

Push the impeller onto the motor. The motor shaft

must not be more than 1.85 mm above the impeller.

cutter arm on page 16 .

motor on page 15 .

mm. Maximum outer diameter: 56 mm.

To remove the

To disassemble the

Repair instructions - 17

Table of Contents