To Assemble The Cylinder - Husqvarna K970 III Workshop Manual

3. Install a snap ring in the piston.
4. Hold the piston in position, push in the wrist pin and
install the other snap ring.
48 - Repair and servicing

6.11 To assemble the cylinder

1. Clean and remove remaining bits of the first gasket
from the surfaces that connect with the gasket.
2. Put the gasket on the cylinder.
3. Make sure that the opening on the piston rings
aligns with the guide pin.
4. Push the piston rings together, use the piston ring
compressor.
1444 - 001 - 02.04.2020