Table of Contents
Advertisement
6. General Notes On Programming
6. 1. Local Programming With an MF4 Telephone
MF4 tones can be used to program the SMarT-1 EuroRoute One-line Dialer. The programming
code is #0 (Register 609) for all country-specific defaults. To exit programming mode and
save data, dial 987, then hang-up. Going on-hook without using the 987 command to exit from
programming mode or remaining inactive in programming mode for more then two minutes
will cause the Dialer to quit programming mode without saving changes, as will dialling the
command 986.
Carrier tone will be heard for the duration of the 011 register (refer to Appendix 2 for the
country-specific defaults) before MF4 programming mode is entered. Setting the 011 register
to a value of 0 will disable the modem and allow you to enter MF4 programming mode
directly.
Note: Do not disconnect the power from the Dialer, until at least 10 seconds have expired after
exiting programming mode. During this period, any programming in the Dialer is being stored
into the Dialer's memory. Disconnecting the power prematurely will result in a loss of
programming, and a checksum error (Refer to page 12).
6. 2. Terminating Variable Length Entries
To terminate a variable length entry (Abbreviated Dialling, Cost Centre Codes, 6rX strings,
etc.) use ##. The entry will be made automatically if you do not enter the ## within the time
specified by the interdigit timer (Register 111: refer to Appendix 2 for the country-specific
defaults).
6. 3. Acknowledgment Tones
While programming the Dialer with an MF4 telephone, you will hear tones that indicate
correct entries, incorrect entries and programming time-outs. In general, after each correct
entry, the Dialer will respond with two tones.
If You Hear
means that the command you have entered has been recognised as being valid (correct), i.e.
you entered # 0
.
If You Hear
means that the entry you have made has been accepted. This occurs after a parameter has
received all the digits it needs to complete programming, or if you have entered ## on a
variable length parameter. For example: if you dial 100 you will hear
.
will hear
8380-383-115-BA
Issue 2, June 1999
CHAPTER 6
General Notes on Programming
, if you then dial 2 you
26
Advertisement
Table of Contents
