9.2.4 mPLC system requirements
Operation system: Windows 7, Windows 8, Windows 10.
9.2.5 Installation of the Software mPLC
When installing the Drive Assistant, mPLC is also automa-
tically installed.
9.2.6 Installation CAN-USB adapter
After mPLC was installed accordingly, the program can
be started. When starting, the program searches automa-
tically for a CAN interface. mPLC supports the CAN-USB
adapter from Dunkermotoren. When opening the „Control
-Center the following message should be indicated in the
status field:
OK: CAN-BUS was initialized
This message appers if the settings are correct and the
CAN-USB adapter was identified accurately.
Version 07.2020 | Page/ Seite 42
9.2.4 mPLC Systemvoraussetzungen
Betriebssystem: Windows 7, Windows 8, Windows 10.
9.2.5 Installation der Software mPLC
Mit der Installation von Drive Assistant wird mPLC automa-
tisch mitinstalliert.
9.2.6 Installation der Software mPLC
Nachdem mPLC ordnungsgemäß installiert wurde, kann
das Programm gestartet werden. Beim Starten wird nach
einer CAN-Schnittstelle gesucht. Standardmäßig unter-
stützt mPLC den CAN-USB Adapter von Dunkermotoren.
Beim Öffnen des „Control Centers" sollte im Statusfeld
folgende Meldung angezeigt werden:
OK: CAN-BUS was initialized
Diese Meldung erscheint, wenn alle Einstellungen korrekt
vorgenommen und der CAN-USB Adapter richtig erkannt
wurde.
www.dunkermotoren.com