Save & Exit Setup; Exit Without Saving - Shuttle XPC User Manual

2. Key in a new password.
The password can not be over eight characters or numbers.
3. The system will then request you to confirm the new password by asking you to
key in the new password again.
4. Once the confirmation is completed, new code is in effect.
No Password Setting:
5. If you want to delete the password, just press the <Enter> key instead of
typing a new password. Follow the procedure as above.
If You Forget Password:
6. If you forget your password, you must turn off the system and clear CMOS.
Please refer to the tech notes at the end of section two for more information.
@
Save & Exit Setup
Press <Enter> on this item to save your changes. The system will ask for
confirmation : system
Pressing "Y" stores the selections made in the menus of CMOS - a special
section of memory that stays on after you turn your system off. The next
time you boot your computer, the BIOS configures your system accord-
ing to the Setup selections stored in CMOS. After saving the values the
system will restart.
@

Exit Without Saving

Press <Enter> on this item to exit without saving changes. The system
will ask for confirmation:
This allows you to exit from Setup without storing in CMOS any change.
The previous selections remain in effect. This exits from the Setup utility
and restarts your computer.
Save to CMOS and EXIT (Y/N)? Y
Quit without saving (Y/N)? Y
27