Shuttle XPC User Manual page 25

Susp,Stby --> Off
All Modes --> Off
Ø The choice: Always On, Suspend ->Off, Susp,stby -> Off, or All
Modes -> Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank: This selection will cause the system to turn off
Blank Screen:This option only writes blanks to the video buffer.
DPMS Supported: Initial display power management signaling.
Ø The choice: V/H SYNC+Blank, Blank Screen, or DPMS Supported.
Switch Function
Enables you to set the System Management Interrupt (SMI) button
function in DOS.
Ø The choice: Disabled or Break /wake.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø The choice: 3, 4, 5, 7, 9, 10, 11, or Auto.
HDD Off After
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disable.
Ø The choice: Disabled, 1 Min ~ 15 Min.
Power Button Override
Pressing the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has "hung.".
Ø The choice: Instant-Off or Delay 4 Sec.
Power State Resume Control
This item enables your computer to automatically restart or return to its
last operating status after power returns from a power failure.
Ø The choice: Always Off, Always On, Keep Pre-state.
Monitor is blanked when the system enters
either Suspend or Standby modes.
Monitor is blanked when the system enters
any power saving mode.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
19