Shuttle XPC User Manual page 22

SiS Serial ATA Controller
Use these item to enable or disable the SiS Serial ATA Controller.
Ø The Choice: Enabled or Disabled.
SiS Serial ATA Mode
This item allows you to set the SATA Mode.
Ø The Choice: IDE Mode, AHCI Mode or Raid Mode.
IDE HDD Block Mode
Select Enabled for automatic detection of the optimal number of block
read/write per sector the drive can support.
Ø The Choice: Enabled or Disabled.
SIS Onboard PCI Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
SIS USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have USB peripherals.
Ø The choice: Enabled or Disabled.
USB 2.0 Supports
Select Enabled if your system contains a Universal Serial Bus 2.0 con-
troller and you have USB peripherals.
Ø The Choice: Enabled or Disabled.
Audio Controller Select
This item allows you to control the onboard Audio.
Ø The Choice: AC97 or Disabled.
SIS Ethernet Controller
This item allows you to enable/disable the SIS Ethernet Controller.
Ø The Choice: Enabled or Disabled.
Onboard LAN Boot ROM
Decide whether to invoke the boot ROM of the onboard LAN chip.
Ø The choice: Enabled or Disabled.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) in-
stalled on the system board and you want to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
Ø The choice: Enabled or Disabled.
16