Advertisement
Never reach into the machine while it
is operating or running down.
To reduce the risk of injury from
moving parts, always keep inlet port
covered with the caps provided, if they
are not connected to a hose.
Make sure that the power cord does
not impede work and cause people to
trip.
Do not operate the machine under the
influence of drugs, alcohol or any
medication. Be aware that medication
can change your behaviour.
Keep children and visitors a safe
distance from the work area.
Never leave a running machine
unattended. Before you leave the
workplace switch off the unit.
Do not operate the electric tool near
inflammable liquids or gases.
Observe the fire fighting and fire alert
options, for example the fire
extinguisher operation and place.
Do not use the dust collector in a
dump environment and do not expose
it to rain.
Do not use this equipment to filter
volatile fumes or smoke.
Wood dust is explosive and can also
represent a risk to health.
Dust form some tropical woods in
particular, and from hardwoods like
beach and oak, is classified as a
carcinogenic substance.
Connection and repair work on the
electrical installation may be carried
out by a qualified electrician only.
Have a damaged or worn power cord
replaced immediately.
3.3 Remaining hazards
When using the machine according to
regulations some remaining hazards
may still exist.
Dust can cause injuries.
The use of incorrect mains supply or a
damaged power cord can lead to
injuries caused by electricity.
Danger of explosion if not properly
grounded.
4. Machine specifications
4.1 Technical data
Dust inlet
Air flow
Vacuum pressure
Collector bag capacity
Overall (LxWxH)
1555x815x380mm
Net weight
Mains
Motor power
Reference current
Extension cord (H07RN-F)
Installation fuse protection
Isolation class
4.2 Noise emission
Acoustic pressure level:
(EN ISO 11202)
LpA 78 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Filter bag
Collection bags (3x)
Mobile casters (4x)
Hose 100 mm
Hose clamps (2x)
Hose ground wire
Operating manual
Spare parts list
4.4 Unit description
Fig 1
A....Filter bag
B....Bag clamp
C....Handle
D....Bag support housing
E....Collection bag
Ø100mm
F....Legs (4)
900 m³/h
G....Casters (4)
H....Base
1050Pa
I.....Hose
55L
J....Motor support housing
K....ON/OFF switch
19 kg
L....Motor
~230V, 50Hz
M...Filter bag hanger
550W
2,7 A
3x1.5mm²
5. Assembly and start up
10A
I
5.1 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the unit!
Dispose of the packing in an
environmentally friendly manner.
Install the casters to the base:
Install four casters to the under side of
the base with bolts, lock washers
washers and nuts (Fig 2)
Motor and bag-support assembly:
Align the motor assembly and bag
support assembly as shwon in Fig 3.
Place the square rubber gasket (N)
into the exhaust port of the motor
assembly (J).
Fig 2
Fig 3
Advertisement
