We will return repaired product or replacement at JET’S expense, but if it is determined there is no defect, or that the defect resulted from causes not within the scope of JET’S warranty, then the user must bear the cost of storing and returning the product.
WARNING Read and understand the entire contents of this manual before attempting assembly or operation. Do not use this machine until proper training and knowledge has been obtained. Do not leave Dust Collector when plugged in. Unplug from outlet when not in use and before servicing.
Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conductor and a grounding plug.
3. The 115V attachment plug supplied with the dust collector must be replaced with a UL/CSA listed plug suitable for 230V operation. Contact your local Authorized JET Service Center or qualified electrician for proper procedures to install the plug. The dust collector must comply with all local and national codes after the 230V plug is installed.
Assembly WARNING The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury! 1. Place motor housing on the floor with the motor fan facing upwards as shown in Figure 1. 2.
Page 9
7. Place the canister filter so that it fits snugly over the housing and tighten the four knobs (A, Fig. 5). 8. Mount handle (B, Fig. 5) to the arm (C, Fig. 5) with a M8 flat washer (D, Fig. 5), M8 lock washer (E, Fig.