Table of Contents
Advertisement
7.5
Crutch support
This accessory holds crutches on the wheelchair without interfering with its normal use.
Put the ends of the crutches into the cup A and fasten their upper ends using the strap B fixed to the backrest post.
You can easily remove the post with the cup by pressing the pin D and sliding the post off the support.
To fit the post with the cup, insert the post into the support C until the pin D touches the support itself. Then, press the pin and slide the post in until the pin locks in the support hole.
7.6
Tray
This accessory can be assembled only if the wheelchair is equipped with armrests.
To install the tray, loosen bolt A of the support S on each side of the wheelchair until the hole is free to let the post go through.
Insert the posts parallel into the supports and slide the tray in to the desired depth.
Finally, tighten the bolt A of both support S.
Before using the tray, make sure it is firmly fixed. Try to move it to-and-fro: if it does not move, it is ready for use.
To remove the tray, loosen the bolt A of the support S on each side of the wheelchair and slide it off.
C
D
A
B
B
A
Basic Light
33
Advertisement
Table of Contents
