Table of Contents
Advertisement
7.7
Headrest
This accessory is designed to give support to the head.
It is suitable for folding wheelchairs; in fact, this type of headrest has a folding structure.
1
When you unfold the wheelchair, the headrest unfolds,
too. To put the headrest in its using position, pull its
structure up until the two tubes A are tilted downward
starting from the central unit B.
2
Before folding the wheelchair, you have to push the
central unit B down.
The user or the attendant can easily adjust the position of
the headrest according to the user's need.
1
3
2
After each adjustment, screw the knob and make sure the system is stable.
Always make a check; in fact, if the system is unstable, it may be cause risky situations.
After loosening the knob of each adjustment, you can also remove the corresponding
parts.
A B A
After unscrewing the knob 1, you can adjust
the height.
After loosening the know 2, you can adjust the
depth.
After loosening the knob 3, you can adjust the
pad by turning it up/down/right/left.
7.8
Crutches support
This accessory holds the crutches on the
wheelchair without creating interference with
the normal use of wheelchair.
Put the ends of the crutches into the cap A
and fix their upper part using the belt B that is
fixed to the backrest tube.
You can easily remove the tube with the cap:
press the pin P and slide the tube off the
support.
To put on the tube with the cap, insert the tube
in the support S until the pin P touches the
same support. Then, press the pin and slide
the tube in until the pin locks in the hole of the
support.
B
S
P
A
Basic Light
25
Advertisement
Table of Contents
