Table of Contents
Advertisement
Assembly
8.6.2 Version with maintenance of gripping force unit
9. Clean all parts thoroughly and check them for defects and
wear.
10. Replace the seals included in the sealing kit.
Observe the permissible screw tightening torques and the greases
and adhesives to be used for the assembly
torques
[
41] and
Grease/greasing areas
}
1. Grease the seal (24) and O-ring (23) and mount them on the
cover housing (11).
2. Grease the guide grooves in the cover housing (11).
3. Grease the running surfaces of the base jaws (3a and 3b).
4. Grease the piston rod (4) in the diagonal pull area, separately
from the lower part of the piston rod (4)
areas
[
40]).
}
5. Push the base jaws (3a and 3b) into the cover housing (11) and
insert the piston rod (4) in the cover housing (11) from above.
Insert the diagonal pull of the piston rod in the grooves of the
base jaws.
6. Fasten the cover (8) to the cover housing using the screws (20).
7. Grease the seals (25) and mount them on the piston (39).
8. Fasten the piston (39) to the piston rod using the screws (19).
9. Glue the magnet into the piston
magnets, item 120
10. Carefully fit the cover housing (11) with the mounted parts
into the bushing (44).
11. Screw the cover housing (11) into the bushing (44) using the
screws (111).
WARNING
Risk of injury due to spring forces
With the "O.D. gripping" version, the bushing (44) or cover
housing (11) is under spring tension.
WARNING
Risk of injury due to spring forces
With the "I.D. gripping" version, the piston (36) is under spring
tension.
06.00 | GSM-Z | Assembly and Operating Manual | en | 389110
[
Mounting orientation of the
[
}
45].
Maintenance
(Screw tightening
40]).
}
(Grease/greasing
43
Advertisement
Table of Contents
