Table of Contents
Advertisement
8.6.2 Version with maintenance of gripping force unit
04.00 | GSM-R | Assembly and Operating Manual | en | 389106
Fit the needle rollers (13 and 14) between the fingers (3) and
Ø
the cover housing (35) into the guide grooves intended for this
purpose.
Lubricate the needle rollers (15) and fit them between the
Ø
fingers (3).
Mount the bracket and the collar (8) with screws (112) onto the
Ø
fingers.
Grease the O-ring (100) and mount it onto the cover housing
Ø
(35).
Fasten the piston (39) to the piston rod (4) using the screw
Ø
(110).
Grease the seals (102) and mount them on the piston (39).
Ø
Glue the magnet into the piston
Ø
magnets, item 120
Carefully fit the cover housing (35) with the mounted parts into
Ø
the bushing (44).
Screw the cover housing (35) into the bushing (44) using the
Ø
screws (111).
WARNING
Risk of injury due to spring forces
With the "O.D. gripping" version, the bushing (46) or cover
housing (35) is under spring tension.
WARNING
Risk of injury due to spring forces
With the "I.D. gripping" version, the piston (36) is under spring
tension.
NOTICE
The needle rollers are suitable only for this product and cannot
be replaced with needle rollers belonging to another product of
the same type and size.
Mounting orientation of the
[
41].
}
Maintenance and care
39
Advertisement
Table of Contents
