Raven CRX Installation Manual page 13

If a ground switch is used in the tractor,

connect the wiring harness behind the ground
switch (not at the battery side of the ground
switch!).
If a main (12V) switch is used in the tractor, the

red wire connect the wiring harness behind the
main switch (not at the battery side of the
main switch!).
If no main switch is used, always connect the

wiring harness directly to the battery.
If the system is connected to a 24 Volt

machine, always use a 24V to 12V converter.
Never connect between the two batteries of a
24V machine!
Lead the terminal harness along with the GPS

and radio/GSM antenna cables through one
pillar of the cab.
Tie-wrap the harnesses so they are attached

free from vibration and friction.
Caution!:
It is important to ensure that the wiring harness
is always connected to the battery AFTER
installing all wires and controllers!
PAGE 13/35 | Installation manual | 016-8000-028EN | Rev. A1
STEERING SYSTEM INSTALLATION | CRX + RS1 | RAVEN EUROPE GENERIC