Table of Contents
Advertisement
EN
Installation
Fig. 5.14
Fitting the control knob
Fig. 5.15
Wave spring when installation is complete
Remove the knob ring [4].
X
X
Unscrew the universal nut [2].
X
X
Remove the wave spring [5].
X
X
Insert the knob housing [1] from the front through the hole in
X
X
the panel.
Attach the wave spring [5] to the knob housing [1] from the
X
X
rear (not in the case of steel fronts).
Screw the universal nut [2] onto the knob housing [1] from the
X
X
rear and tighten a little.
Align the knob housing [1] so it is level.
X
X
Tighten the universal nut [2].
X
X
The wave spring (if used) must be pressed flat.
O
X
Remove the sticker [3].
X
X
Place the knob ring [4] on the knob housing [1].
X
X
5.7
Installing the cooktops
i
Clearance of one millimetre should be planned between
the built-in appliances.
i
A clearance of two millimetres should be planned around
the built-in appliances.
i
It is recommended to install a mounting rail between
adjacent cooktops (mounting rail PZMS available as an
accessory).
i
The cooktop can also be installed rotated by 180°.
18
5.7.1 Installing the cooktop
Inserting the Tepan stainless steel grill PKT3 (ports
on the back)
1
Fig. 5.16
Inserting the cooktop
[1]
Worktop cut-out
[2]
Tepan stainless steel grill
[3]
Control knob and automatic extractor function ports
Insert the Tepan stainless steel grill [2] into the worktop cut-
X
X
out [1].
Precisely align the Tepan stainless steel grill [2].
X
X
For a normal installation, please note that the ports for the
X
X
control knobs and the automatic extractor function [3] are at
the rear.
Levelling the cooktop (if necessary)
Fig. 5.17
Cooktop and height adjustment plates
[1]
Cooktop
[2]
Height adjustment plates
If applicable, insert the height adjustment plates [1].
X
X
2
3
1
2
www.bora.com
Advertisement
Table of Contents
