Table of Contents
Advertisement
EN
Installation
5
Installation
Observe all safety and warning information (see the "Safety"
X
X
chapter).
Follow the enclosed manufacturer's information.
X
X
5.1
General installation instructions
i
The appliances must not be installed above cooling
devices, dishwashers, stoves, ovens, washing machines
or dryers.
i
The contact surfaces of the worktops and wall sealing
strips must be made of a heat-resistant material (up to
approx. 100 °C).
i
Worktop cut-outs must be moisture-sealed using suitable
means and, where necessary, fitted with a thermal
insulator.
i
External devices may only be connected to the cooktop
extractor connections provided.
i
Extremely bright lights aimed directly at the appliances
can cause colour variations in the appliances and are
thus to be avoided.
General installation instructions for cooktops
i
To ensure that the cooktops perform optimally at all
times, there must be sufficient ventilation beneath the
cooktops.
i
The performance of the cooktops is affected or the
cooktops overheat if the warm air beneath the cooktops
cannot escape.
i
If a cooktop overheats, the power is automatically
reduced or the cooktop is switched off completely (see
"Overheating protection").
i
If cable protection (false floor) is planned beneath the
appliance, this must be fitted so it does not obstruct
ventilation.
Make sure that the area below the cooktop has a sufficient air
X
X
supply.
5.2
Checking the scope of delivery
Make sure the delivery is complete and check it for damage.
X
X
If there are any missing or damaged parts, please notify the
X
X
BORA After Sales Service.
Do not under any circumstances install parts which are
X
X
damaged.
Dispose of transport packaging in the proper manner (see the
X
X
"Decommissioning, disassembly and disposal" chapter).
14
Name
Cooktop
Control knob
Operating and installation instructions
Cooktop mounting screws
Height adjustment plate set
Cooktop mounting straps
Control knob cable
Automatic extraction system cable
Special scope of delivery for Tepan stainless steel grill
Tepan spatula
Tab. 5.1
Scope of delivery of the cooktops
5.3
Tools and aids
The following tools are required to correctly install the appliance:
pencil
O
X
tape measure or folding metre stick
O
X
standard or cordless drill with Ø 50 mm Forstner bit
O
X
black, heat-resistant silicone sealant
O
X
slotted screwdriver
O
X
size 20 Torx screwdriver
O
X
5.4
Assembly instructions
5.4.1 Safety clearances
Maintain the following safety clearances:
X
X
3
2
Fig. 5.1
Minimum distance
[1]
Minimum clearance of 50 mm at the back from the worktop
cut-out to the rear edge of the workto
[2]
Minimum clearance of 300 mm from the left and right of the
worktop cut-out to the adjacent cabinet or wall.
[3]
Minimum clearance of 600 mm between the worktop and the
wall unit.
Quantity
1
2
1
4
1
4
2
1
1
1
www.bora.com
Advertisement
Table of Contents
