Opening The Loading Door - BÖWE M12 Instruction Manual

6. Operation

6.1.11. Opening the Loading Door

Never leave the loading door standing open!
Before each start, make sure that the loading door is closed.
During longer standstills, concentrations of the solvent gas can form.
In this case, we recommend that you run program P43 before you open the loading door.
Once the machine has been turned on, it is not possible to open the loading door until the
"DEODORIZING" program (P43) starts and the horn sounds to signal the end of the program.
Attention: When neither current nor compressed air is present or
Caution
The trained user is permitted to carry out an EMERGENCY opening only when the program has
stopped and the cage is not turning. Before the emergency opening, carefully open the button trap
cover in order to release any overpressure.
After removing garments that have not finished drying, place them in a solvent-tight transport
container. Obey the safety regulations.
Emergency release:
Emergency release
There is an 8-mm (.3 in) ∅ bore hole in the paneling, to the left of the loading door, that you can use
to release the lock.
Use a screwdriver to press the bolt to the left and open the loading door.
After correcting the error, close the loading door and cover and continue the program by pressing
the "Start" button.
31
when the program has been interrupted, a mechanical
EMERGENCY opening is possible with the help of a tool.
6.
703887-03-B-01
M12/M15/M18