Programming The Locomotive Decoder - tams elektronik LD-G-2 Manual

English
Connection
Contact
1 Motor connection 1
2 Lighting back (-)
3 Not used or F1
4 Power supply left
5 Motor connection 2
6 Lighting front (-)
7
Common conductor
for all functions (+)
8 Power supply right

Programming the locomotive decoder

You can make the following adjustments from the central unit without
intervention at the locomotive:
1. Locomotive address
2. Assignment of the function outputs to the function keys
3. Dimming the function outputs
4. Kick function of the function outputs
5. Load control: active or inactive
6. Definition of the forward direction
7. Velocity at speed level 1 for velocity characteristic 1
8. Maximum speed for velocity characteristic 1
9. Velocity at speed level 1 for velocity characteristic 2
10. Maximum speed for velocity characteristic 2
11. Automatic shuttle service: active or inactive
12. Acceleration delay
13. Brake delay
14. Parameters of the load control
Page 16
Colour of cable
orange
yellow
green
black
grey
white
blue
red
LD-G-2
Connecting points
X7
X3
X1
X8
X6
X4
X5
X9