Adjustment Of The Transmission's Neutral Position - Husqvarna Rider 13 AWD Workshop Manual

Adjustment of the transmission's neutral position

1. Bleed the drive system, see "Bleeding
the drive system".
2. Lift the rear of the Rider, front and back,
so that the all wheels spin freely and
place jack stands under the machine.
3. The neutral position is adjusted by
turning the hexagonal shaft on the
transmission (see figure).
Start the engine and turn the throttle to
full.
Method 1
1 = Shaft
2 = Lock nut
• Turn the shaft slowly counter-clockwise
until the drive shafts stop rotating
backwards and make a mark on the
transmission housing (RS).
• Turn the shaft slowly counter-clockwise
until the drive shafts begin rotating
forwards.
• Turn the shaft slowly clockwise until the
drive shafts stop rotating forwards and
make a mark on the transmission
housing (FS).
• Turn the shaft clockwise 1/3 of the
distance between the two marked stop
points.
• Hold the shaft still (N=8) and tighten the
lock nut (N=17).''
• Check that the drive shafts do not rotate
in the neutral position from the forward
and reverse positions.
• Loosen the lock nut on the hexagonal
shaft and turn the shaft clockwise until
the drive shafts begin to rotate
backwards.
• Make a mark on the top of the shaft.
REPAIR INSTRUCTIONS
8009-852
6012-061
93
English-