Husqvarna Rider 13 AWD Workshop Manual page 85

3. Place the seal on the shaft with the
smooth side up and press it carefully
down.
Use the thick end of a 1/4" extender to
carefully tap the seal down until the top
of the seal is even with the upper edge of
the shaft housing. Move the extender in
a circle around the seal so that it is
pressed down evenly all around.
Remove the insulation tape from the
shaft and fit the lower circlip and belt
pulley with the hexagonal hub face up.
Fit the fan and the washer and the upper
circlip.
Seal Replacement, Outgoing Shafts
1. Remove the circlips that hold the wheels
onto the shafts and remove the wheels
by pulling them outwards. Do not lose
the key that sits between the wheel and
the shaft.
2. Remove the spacers and washers. Keep
count of the number of washers, this can
vary between sides.
IMPORTANT INFORMATION
Dirt must not enter the transmission since
this will shorten the transmission's life.
3. Clean the outgoing shaft and the area
around the seal from all dirt and rust.
4. Insert a screwdriver between the seal
and the shaft and pry off the seal from
the shaft housing with a twisting motion.
A small amount of oil can leak out.
84
English-
REPAIR INSTRUCTIONS
The wheel's circlip
Pry off the seal
6012-044
8009-825
6012-045