Husqvarna Rider 13 AWD Workshop Manual page 52

12. Push tool no. 506 56 76–01 into the cen-
tre of the engine belt pulley. Loosen and
remove the Allen screw that holds the
belt pulley and engine shaft together.
Use tool no. 506 89 92–01 to counter.
Loosen the belt pulley from the engine
shaft.
13. Use the 506 66 00 48–01 puller if
necessary.
14. Remove the engine fixtures, two on each
side of the engine, and remove the
engine from the rider. The figure shows
the right-hand side. For the left side, see
the illustration under "Assembling".
REPAIR INSTRUCTIONS
Engine belt pulley
Engine belt pulley remover
The engine's fastening screws, right side. Mount not
shown
506 56 76-01
8009-194
506 66 48-01
8009-518
8009-192
English-
51