Husqvarna Rider 13 AWD Workshop Manual page 37

10. Insert tool, part number 506 79 06–01, in
the centre of the engine belt pulley.
Loosen and remove the Allen screw that
holds the belt pulley and engine shaft
together.
Use tool, part number 506 89 92–01, to
counterhold. Loosen the belt pulley from
the engine shaft.
11. Use the puller, part number 506 66 48–01,
if necessary.
12. Remove the engine's fixtures, two on
each side of the engine.
Watch where the battery's negative
cable is connected. Disconnect it from
the engine if necessary.
Lift the engine out of the mower, take
care of the key and spacer tube, located
on the engine shaft.
36
English-
REPAIR INSTRUCTIONS
6012-008
506 66 48-01
8009-518
8009-419
8009-420