Table of Contents
Advertisement
FRONT-TO-BACK ADJUSTMENT (See Fig. 16).
IMPORTANT: DECK MUST BE LEVEL SIDE-
TO-SIDE. IF THE FOLLOWING FRONT-TO-
BACK ADJUSTMENT IS NECESSARY, BE
SURE TO ADJUST BOTH FRONT OR BOTH
REAR LINKAGES EQUALLY SO THE DECK
WILL STAY LEVEL.
To obtain the best cutting performance, the deck
should be adjusted so the front tip of the blades
are approximately 1/8" to 1/4" lower than the rear
tip. If the front tip is higher, this will create a poor
quality of cut.
WARNING
Blades are sharp. Protect your hands with
gloves and/or wrap blades with a heavy
cloth when handling.
Check adjustment on the right side of the
mower. Position any blade so that the tip is
pointing straight forward. Measure distance "B"
at the front and rear tip of the blade.
•
Before making any necessary
adjustments, check to make sure that
the deck is level side-to-side.
•
With the deck in the highest cutting
position, (4 1/2") measure the front tip of
the blade to see if the deck is higher or
lower than 4 1/2".
•
To lower the front tip of the blade, using a
9/16" wrench, loosen the hex nuts that
are on the front lift linkages (be sure to
loosen equal amounts).
•
When distance "B" is 1/8" to 1/4" lower at
the front than rear the adjustment is
done.
•
Reverse above step to raise the deck.
SERVICE AND ADJUSTMENT
B
FIGURE 16
TO REPLACE DECK BELT
DECK BELT REMOVAL (See Fig. 17 and 18)
•
Park on a level surface. Apply park
brake.
•
Lower the deck into the lowest cutting
position
•
Disengage the tension relief lever from
the lock bracket.
Lever is spring loaded. Have a tight grip
on the lever and release slowly.
•
Remove screws from both the left and
right belt shields, and remove shields.
•
Remove any dirt or grass that may have
accumulated around the cutter housings
and entire deck surface.
•
Carefully roll the belt over the top of the
cutter housing pulleys.
•
Remove the belt from around the electric
clutch on the engine shaft.
•
The belt can now be removed.
25
B
WARNING
Hide quick links:
Advertisement
Table of Contents
