Homing Menu - CraftBot CB4 FLOW Series User Manual

Hide thumbs Also See for CB4 FLOW Series:
Table of Contents

Advertisement

8. HOMING MENU

Select the Homing menu
The small house icon
location in the front left corner of the build plate. You can reset the extruder and
the build plate to the "home" or "zero" position.
You can either set each axis one at a time (X,
of them at once by touching the appropriate button. If the individual house icons
are white, then this means that the motors of each highlighted icon are engaged
(working).
To disengage the motors, click on the icon in the right bottom corner
X through it), and you will see all of the house icons turn grey. The motors have now
been disengaged (not working) and you can freely move the extruder by hand if you
wish to do so.
The left control panel controls the extruder along the X and Y axes. We can move
motors that have the house icon filled in. You can control the extruder by dragging
the center button in one direction from the center to the outside. The head also
moves according to the pull direction.
You can use the up
housing icon is full.
on the Home screen.
indicates the „home" position of the extruder which is
and down
arrows to move the build plate when the Z
Y
or Z
), or do all three
(M with an
23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CB4 FLOW Series and is the answer not in the manual?

This manual is also suitable for:

Flow idex xlFlow xl

Table of Contents