Table of Contents
Advertisement
Available languages
Available languages
Operating the appliance
CAUTION: Hazard of injury and burns!
• Prior to operation, ensure that the crumb tray is inserted
below the lower heating element!
• Heating plates, surfaces of the casing, trays, grid, crumb tray
and accessory parts are getting hot during use!
• Hot surfaces firstly stay hot after switch-off!
• Make sure the food touches neither the upper, nor the lower
heating rod when inserting it!
• On the heating plates, only use cooking vessels of suitable
diameter!
1. Connecting the appliance to the power supply
2. Operating the heating plates
a. Switching the heating plates ON/OFF
• Each heating plate is equipped with a 4-step switch:
Level 0:
Off
Level 1:
Cooking small quantities, warming-up, keeping warm
Level 2:
Cooking larger quantities, roasting, stewing
Level 3:
Full power to start cooking
• Nominal consumption:
level 1
level 2
level 3
22
ATTENTION: Before connecting the appliance to the power supply,
make sure that all rotary knobs are in position „0"!
• Connect the power plug with an adequately protected power socket.
• The appliance is now ready for operation.
Large heating plate 180 mm Ø
400 W
600 W
1000 W
• The selection of the function for the large heating plate is done via the
third rotary knob (D) from above.
• Select the desired level by turning the switch to the right.
• The selection of the function for the small heating plate is done via the
fourth rotary knob (F) from above.
• Select the desired level by turning the switch to the right.
• Turn the rotary knob to position "0" once the cooking process is finished!
NOTE: The appliance is equipped with a pilot lamp (E). Once both heating
plates are switched on, the pilot lamp glows permanently. The pilot lamp goes
out when both plates are switched off.
Small heating plate 145 mm Ø
300 W
450 W
750 W
Advertisement
Table of Contents
