Valor G3.5 Installation Manual page 32

Appendix B—Remote Control Operation
Circulating Fan Operation
(if equipped)
Circulating fan has 4 speed levels from
low to high (1 to 4 bars).
Press SET to scroll to
level icons fl ash.
To set speed, press fl ame buttons:
= increases speed.
= decreases speed and
turns OFF fan when all bars disappear.
Note: 8 seconds after the fan is set, handset goes
automatically in temperature control mode. Fan
starts 4 minutes after gas opens (from OFF or
pilot) at maximum speed then goes to displayed
level after 10 seconds. Fan stops 10 minutes after
gas is OFF or at pilot.
Setting high / low Temperatures
Setting "DAYTIME" high temperature.
Default Settings:
TEMP
Press SET to scroll to
Hold SET button until TEMP fl ashes.
To set Daytime Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
Setting "NIGHT TIME SETBACK" low temperature.
Default Settings:
T E M P
Press SET to scroll to
Hold SET button until TEMP fl ashes.
To set Night Time Temperature:
= increases temperature.
= decreases temperature.
Press or wait to complete setting.
32
. Fan and
23 °C/74 °F
TEMP
"--" (OFF)
T E M P
Setting Program Timers
You can program two periods of time between 12 am
and 11:50 pm in each 24-hour cycle.
Programs P1 and P2 must be set in the following order
during a 24-hour cycle:
= Day Time temperature (high) program period
= Night Time temperature (low) program period
Default Settings:
Program 1: 06:00 am
P1
Program 2: 11:50 pm
P2
Press SET to scroll to
TIMER
If =
P1 P1
programming is cancelled.
To keep fi replace ON all night, set
11:50 am and
If you want to program only one period,
program
P1
then and
P2
as .
P1
Setting P1 time - high temperature.
Hold SET button until
P1
fl ashes.
To set time:
= hour
= minutes
Press or wait to complete setting.
Setting P1 time - low temperature.
Hold SET button until
P1
and time fl ashes.
To set time:
= hour
= minutes
Press or wait to complete setting.
, , and
P1 P1
P2
08:00 am
P1
11:50 pm
P2
.
or = ,
P2 P2
P2
at 12:00 am.
P1
and with desired times
P1
with the same time
P2
is displayed and time
is displayed
.
P2
at