Multiple Act Fresnels (Dmx Control) - SHOWTEC ACT Fresnel 50 WW Manual

ACT Fresnel 50 WW

Multiple ACT Fresnels (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Secure the device with a safety cable (order code 70140 / 70141).
03) Use a 3-pin DMX cable to connect the ACT Fresnel and other devices.
04) Link the units as shown in Fig. 13. Connect a light controller to the first unit's DMX "in" socket, using a
DMX cable. Connect the first unit's "out" socket with the second unit's "in" socket, using a DMX
cable. Repeat this process to link the rest of the units.
05) Supply electric power: Plug electric mains power cords into each unit's power IN socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
06) Refer to 1. DMX Functions on pages 16–17 for more information about the DMX settings.
Order code: 34011
Note: Link all cables before connecting electric power
12
Fig. 13