Install The Rcf - Remote Controller; Install The Vision Lite; Install The Ags - TBB Energier Pro Series User Manual

6.6 Install the RCF - remote controller

The RCF was dash mounting design. Please cut the hole (refer to 3.2.2) and screw the remote controller securely through four screws
at corners and connected the cables.
Connect the RCF to the "remote interface" of Energier pro bi-directional inverter with RJ45 cable, please refer to following figure.

6.7 Install the Vision Lite

Connect the Vision Lite to the "RS485 interface" of Energier pro bi-directional inverter with the cable, please refer to following figure.

6.8 Install the AGS

Please find following the wiring guide of AGS to Energier pro bi-directional inverter and Generators.
Connect the AGS to the "AGS interface" of Energier pro bi-directional inverter with the cable, please refer to following figure.
37
Energier pro User Manual