7.4 Switch on the inverter
Disconnect the AC input power, switching on the unit, the LED will all illuminate for analysis then there should be AC available at
inverter output. The inverter LED will illuminate. You could switch on the load which will be powered by inverter.
The Load % LEDson remote will reflect the load level connected.
The Battery SOC LEDson remote will reflect the battery condition, which are 25%-50%-75%-100% respectively from bottom.
7.5 Switch on Charger
Then switch on the AC input power, Energier pro bi-directional inverter should go on bypass mode feeding the power to load
and meantime battery charger will start work.The bypass LED and charger LED on front panel will illuminate.
The AC in LED and Charger LED on remotewill illuminate .
While connecting to a generator, in case you could not get charging after connecting in, you need to switch off the inverter and
change the work mode and repeat 7.4.
The Load LEDs on remote will reflect the present charging power.
The Battery SOC LEDson remote will reflectthe charging status.
7.6 Switch off AC input
Remove the AC input, the Energier pro bi-directional inverter will transfer to inverter mode quickly and load should continue work
without interruption. Inverter LED will illuminate.
40
Energier pro User Manual