Inlet Hoses - Fisher & Paykel WA8060P Installation Instructions Manual

• This appliance must be installed in accordance with the installation instructions before use.
• Provide accessibility to the plug or incorporate a switch in the fixed wiring in accordance with the
• Do not operate this washer if it has been damaged during transport. Contact your Fisher &

Inlet hoses

WARNING: Failure to adhere to the following instructions may result in a flood and damage
to property.
1. Connect the straight ends of the inlet hoses to the taps (there are washers fitted in both ends). Connect the red
connector hose to Hot, and the white connector hose to Cold.
2. Connect the elbow ends of the inlet hoses to the corresponding washer inlet valves. Inlet valves are marked on
the back of the washer. Ensure the Hot valve is connected to the hot tap and the Cold valve is connected to the
cold tap.
H = Hot C = Cold
Cold water supply only:
If you only have a cold water supply, a blanking cap MUST be connected to the Hot inlet valve. The cap prevents water
leaking out of the hot valve. The cap is available from your Fisher & Paykel dealer or Fisher & Paykel trained and
supported service technician, Part No. 388491P. This appliance incorporates backflow protection complying with
AS3500.1. No further backflow protection is required for connection to the water supply.
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/FabricSmart/WA8560P1/User_Guide_WA8560P1/03_Installation...
wiring rules to allow disconnection of the appliance from the supply after installation.
Paykel dealer or Fisher & Paykel trained and supported service technician.
• New hose sets provided with the washer shall be used to connect the washer to the water
supply.
• Old hose sets should not be used.
• We recommend replacing the inlet hoses every 5 years.
• Hoses should be checked from time to time and replaced if any wear, cuts, bulges, kinks or
leaks are found.
Updated: Wed, 26 Feb 2020 08:47:21 GMT
Powered by
6