Modbus Register Table; Specifications - Banner SureCross DX80 Series Manual

SureCross DX80 Node
LED Behavior for the Nodes
After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. A Node will not sample its
inputs until it is communicating with its Gateway. When testing communication between the Gateway and Node, all radios and antennas
should be at least two meters apart or the communications may fail.
LED 1
(flashing green)
(flashing red)

Modbus Register Table

I/O Modbus Holding Register
Gateway / Any Node
DX85
1 1 1 + (Node# × 16)
2 2 2 + (Node# × 16)
3 3 3 + (Node# × 16)
4 4 4 + (Node# × 16)
5 5 5 + (Node# × 16)
6 6 6 + (Node# × 16)
7 7 7 + (Node# × 16)
8 8 8 + (Node# × 16)
9 9 9 + (Node# × 16)
10 10 10 + (Node# × 16)
11 11 11 + (Node# × 16)
12 12 12 + (Node# × 16)
13 13 13 + (Node# × 16)
14 14 14 + (Node# × 16)
15 15 15 + (Node# × 16)
16 16 16 + (Node# × 16)

Specifications

Range
900 MHz: Up to 4.8 kilometers (3 miles)
2.4 GHz: Up to 3.2 kilometers (2 miles)
Transmit Power
900 MHz: 21 dBm conducted
2.4 GHz: 18 dBm conducted, less than or equal to 20
dBm EIRP
P/N 132162 Rev. H
LED 2
(flashing red)
(flashing red, 1 per 3 sec)
I/O Type I/O Range
Min.
Discrete IN 1 0
Discrete IN 2 0
Discrete IN 3 0
Discrete IN 4 0
Discrete IN 5 0
Discrete IN 6 0
Reserved
Device Message
Discrete OUT 1 0
Discrete OUT 2 0
Discrete OUT 3 0
Discrete OUT 4 0
Discrete OUT 5 0
Discrete OUT 6 0
Control Message
Reserved
Radio and General
Power
www.bannerengineering.com - tel: 763-544-3164
Node Status
Radio Link Ok
Device Error
No Radio Link
Holding Register Representa-
tion
Max. Min. (Dec.)
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
Requirements: +10 to 30V dc (Outside the USA: +12 to
24V dc, ±10%). (See UL section below for any applica-
ble UL specifications)
Consumption: Less than 1.4 W (60 mA) at 24V dc
Terminal
Block La-
bels
Max. (Dec.)
1 DI1
1 DI2
1 DI3
1 DI4
1 DI5
1 DI6
1 DO1
1 DO2
1 DO3
1 DO4
1 DO5
1 DO6
5