Adjusting The Anti-Scalp Rollers - Toro TITAN HD 1500 Series Operator's Manual

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
(also the 127 mm or 5 inch cutting-height
position) as shown in
3. Remove the pin from the height-of-cut bracket
(Figure 35).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
Figure 35
1. Deck-lift pedal
2. Height-of-cut holes
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to Engaging the Parking Brake
(page 26).
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
position.
OCK
position
RANSPORT
Figure 35.
35).
3. Height-of-cut pin
4. Transport lock knob
3. Adjust the anti-scalp rollers as shown in
36 or Figure
2500 Series mower deck shown
1. Anti-scalp roller
2. Spacer
3. Bushing
g036745
1500 and 2000 Series mower deck shown
1. Flange nut
2. Bolt
3. Bushing
32
37.
Figure 36
4. Flange nut
5. Bolt
Figure 37
4. Anti-scalp roller
5. Spacer
Figure
g038079
g036848