Toro TITAN HD 1500 Series Operator's Manual page 53

Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
Do not wash the paper element or use
pressurized air, as this will damage the element.
Note:
Replace a dirty, bent, or damaged
element. Handle the new element carefully;
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Air Cleaner
1. Install the foam element over the paper element.
Note:
Ensure that you do not damage the
elements.
2. Align the holes of the filter into the manifold
ports.
3. Rotate the filter down into the chamber and fully
seat it against the manifold
Figure 71
4. Close the cover.
(Figure 71).
g228022
53
Servicing the Air Cleaner
Engines with a Heavy-Duty Air Cleaner
Service Interval: Every 250 hours—For Toro
engines with a heavy-duty air
cleaner—replace the air filter (more
often in dusty or sandy conditions).
Note:
Check the filters more frequently if the
operating conditions are extremely dusty or sandy.
Removing the Filters
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(Figure 73).
Figure 72
1. Air-cleaner body
2. Filter
4. Clean the inside of the air-cleaner cover with
compressed air.
5. Gently slide the filter out of the air-cleaner body
(Figure 73).
Note:
Avoid knocking the filter into the side of
the body.
Inspecting the Filter
Inspect the filter for damage by looking into the filter
while shining a bright light on the outside of the filter.
If the filter is dirty, bent, or damaged, replace it.
Note:
Holes in the filter appear as bright spots. Do
not clean the filter.
g230914
3. Latch
4. Air-cleaner cover