Toro TITAN HD 1500 Series Operator's Manual page 68

9. Remove the belt from the remaining pulleys
(Figure 97).
10. Route the new belt abound the mower pulleys.
11. Using the ratchet in the square hole, remove the
tension on the spring, and guide the new belt
around the idler pulley
Replacing the Mower Belt
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches) height
of cut.
4. Remove the belt covers
5. Remove the counter-rotating belt; refer to
Replacing the Counter-Rotating Belt (page
6. Use a ratchet in the square hole in the idler arm
to remove tension on the idler spring
7. Remove the belt from the mower-deck pulleys
and the clutch pulley.
8. Install the new belt around the mower pulleys
and the clutch pulley under the engine
99).
(Figure 97).
(Figure 98).
Figure 98
(Figure
1. Mower belt
2. Spring-loaded idler pulley
9. Rotate and ensure the belt-guide tab hits against
the pivot hub
10. Using the ratchet in the square hole, install the
belt around the spring-loaded idler pulley
99). Seat the spring ends in the anchor grooves.
11. Install the counter-rotating belt; refer to
Replacing the Counter-Rotating Belt (page
12. Install the belt covers
g027729
67).
99).
(Figure
68
Figure 99
3. Square hole in the idler
arm for the ratchet
4. Counter-rotating belt
(Figure 99).
(Figure 100).
Figure 100
g036863
(Figure
67).
g027730