Toro TITAN HD 1500 Series Operator's Manual page 75

Figure 110
1. Cutting edge
2. Curved area
Checking for Bent Blades
Note:
The machine must be on a level surface for
the following procedure.
1. Raise the mower deck to the highest
height-of-cut position.
2. While wearing thickly padded gloves, or other
adequate hand protection, slowly rotate the
blade into a position that allows you to measure
the distance between the cutting edge and the
level surface the machine is on
Figure 111
1. Deck
2. Spindle housing
3. Measure from the tip of the blade to the flat
surface (Figure 112).
g006530
3. Wear/slot forming
4. Crack
(Figure 111).
g014972
3. Blade
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position (Figure
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat
surface (Figure
Note:
The variance should be no more than
3 mm (1/8 inch).
75
Figure 112
113).
Figure 113
114).
g014973
g014974