Oil Into The Filler Tube And Slowly Add The Additional Oil To Bring It To The Full Mark - Toro TITAN HD 1500 Series Operator's Manual

5. Change the engine-oil filter
Note:
Ensure that the oil-filter gasket touches
the engine and then turn the filter an extra 3/4
turn.
Figure 76
6. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
77).
(Figure 76).
g027477
(Figure
56
Figure 77
Servicing the Spark Plug
Service Interval: Every 100 hours/Yearly
(whichever comes first)—For
Toro engines—check the spark
plug(s).
Every 200 hours/Every 2 years (whichever
comes first)—For Toro engines—replace the
spark plug(s).
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
®
Type: Champion RN9YC or NGK
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the area around the base of the plug to
keep dirt and debris out of the engine.
4. Remove the spark plug
g193530
®
BPR6ES
(Figure 65).