Toro TITAN HD 1500 Series Operator's Manual page 60

WARNING
Incorrectly removing the cables from
battery could damage the machine and
cables, causing sparks. Sparks can
cause the battery gasses to explode,
resulting in personal injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
4. Slide the rubber cover off the positive (red)
cable.
5. Disconnect the positive (red) cable from the
battery post (Figure
Note:
Retain all fasteners.
6. Remove the rubber strap
7. Remove the battery.
Figure 82
82).
(Figure 82).
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from the battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the chassis; refer to
Removing the Battery (page
2. Charge the battery for 10 to 15 minutes at 25 to
30 A or for 30 minutes at 10 A.
Note:
Do not overcharge the battery.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure
4. Install the battery in the machine and connect
the battery cables; refer to
(page 61).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
g036853
1. Positive (+) battery post
2. Negative (–) battery post
g036855
60
59).
83).
Installing the Battery
Figure 83
3. Red (+) charger lead
4. Black (–) charger lead
g000960