Toro TITAN HD 1500 Series Operator's Manual page 48

Removing the Elements
1. Rotate the latches outward.
2. Remove the cover to access the air-cleaner
elements (Figure
1. Air-cleaner cover
3. Remove the foam and paper elements
59).
4. Remove the foam element from the paper
element (Figure
1. Air-cleaner cover
2. Foam element
Servicing the Foam Element
1. Wash the foam element in liquid soap and
warm water. When the element is clean, rinse
it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
Important:
Replace the foam element if it
is torn or worn.
58).
Figure 58
2. Air-cleaner latch
59).
Figure 59
3. Paper element
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
pressurized air, as this will damage the element.
Note:
element. Handle the new element carefully;
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
(Figure
3. Install the cover, and secure it with the latches
(Figure
g028105
Servicing the Engine Oil
Engine Oil Specifications
Oil Type: Detergent oil (API service SJ or higher)
(Figure
Crankcase Capacity: 1.9 L (64 fl oz) with the oil filter
Viscosity: See the table below.
g028106
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
Important:
crankcase with oil and run the engine, you may
damage the engine.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
48
Do not wash the paper element or use
Replace a dirty, bent, or damaged
59).
58).
Figure 60
If you overfill or underfill the engine
g017552