Toro TITAN HD 1500 Series Operator's Manual page 79

8. Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9. Place 2 blocks (see table below) under the rear
edge of the cutting deck skirt; 1 on each side of
the cutting deck
10. Set the height-of-cut lever to the 3 inch (76 mm)
position.
11. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
Figure 122
Bottom view
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
Deck Size Block Height
All mower 7.3 cm (2.87 inches)
decks
12. Carefully rotate the blades side to side
120).
13. Loosen the locknuts
corners and ensure that the mower deck is
sitting securely on all 4 blocks.
14. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
15. Tighten the 4 locknuts.
(Figure 122).
2. Welds
Rake
4.8 to 6.4 mm (3/16 to 1/4
inch)
(Figure 123) on all 4
1. Locknuts
2. Deck-lift arm
16. Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
g038090
17. Continue leveling the deck by checking the
front-to-rear blade slope.
18. Check the blades for levelness and repeat deck
leveling procedure if necessary.
(Figure
79
Figure 123
3. Deck hanger
4. Chain
g035851