Toro TITAN HD 1500 Series Operator's Manual page 46

Changing the Engine-Oil Filter
Service Interval: Every 200 hours—For Kawasaki
engines—change the engine-oil
filter (more often in dirty or dusty
conditions).
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Change the engine-oil filter
Figure 53
Note:
Ensure that the oil-filter gasket touches
the engine, and then turn the oil filter an extra
3/4 turn.
3. Fill the crankcase with the proper type of new
oil; refer to Engine-Oil Specifications (page
Changing
44).
(Figure 53).
44).
Servicing the Spark Plug
Service Interval: Every 100 hours
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
Type of Spark Plug: NGK
Air Gap: 0.75 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
g036856
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the area around the base of the plug(s) to
keep dirt and debris out of the engine.
4. Locate and remove the spark plug(s) as shown
in Figure
g027477
46
® BPR4ES or equivalent
54.
Figure 54
g036857
g027478