Hidden Features; Program Customization; Programmable Delay Between Stations - Hunter PRO-C PC Series Owner's Manual And Installation Instructions

HIDDEN FEATURES

Program Customization

The Pro-C is factory-configured with 3 independent programs
(A, B, C with four start times each) for different plant type
requirements. The Pro-C can be customized to display only the
required programs. You can hide those programs that are not
required to ease programming.
1. Start with the dial in the RUN position.
2. Press and hold the - button. Turn the dial to the WATER DAYS
position.
3. Release the - buttons.
4. Use the + and - button to change program modes.
Advanced Mode
(3 programs / 4 start times)
Limited Mode
(1 program / 1 start time)
34
Normal Mode
(2 programs / 4 start times)

Programmable Delay Between Stations

This feature allows the user to insert a delay between when
one station turns off and the next station turns on. This is
very helpful on systems with slow closing valves or on pump
systems that are operating near maximum flow or have slow
well recovery.
1. Start with the dial in the RUN position.
2. Press and hold the - button while turning the dial to the
RUN TIMES position.
3. Release the - button. The display
will show a delay time for all
stations in seconds.
4. Press the + and - buttons to
increase or decrease the delay time
between 0 and 59 seconds in 1-second increments and then
in 1-minute increments up to 4 hours. Hr will be displayed
when the delay changes from seconds to minutes and hours.
Maximum delay is 4 hours.
5. Return the dial to the RUN position.
NOTE: The Master Valve/Pump Start
circuit will operate during the first 15
seconds of any programmed delay to
aid in the closing of the valve and to
avoid unnecessary cycling of the pump.