Hunter PRO-C PC Series Owner's Manual And Installation Instructions page 39

HIDDEN FEATURES
Accessing the Soak Menu:
Once the desired Cycle times for each station have been
programmed, the Cycle time can be accessed by pressing the
PRG button.
The station will remain the same as was previously displayed
under the Cycle time (i.e., if station 2 is displayed in the Cycle
menu then Station 2 will be displayed upon pressing the
PRG button).
NOTE: The Soak menu cannot be accessed
without a programmed Cycle time.
Setting the Soak Time:
To access the other stations, press the ← or→button.
NOTE: When changing the stations,
if a station without a Cycle time is
encountered, the screen will revert back
to the Cycle time. Move to the next station
with a Cycle Time and press the PRG
button to return.
(CONTINUED)
Once the desired station is displayed, the user can use
the + or - button to increase or decrease the Soak time.
The user can set the Soak time from 1 minute to 4 hours
in 1-minute increments.
Example of Soak screen with
only minutes
Cycle and Soak Situations:
Station 1 requires 20 minutes of watering, but after 5 minutes,
runoff occurs. However, after 10 minutes all the water is
absorbed. The solution would be to program 20 minutes for
the station run time, 5 minutes for
the Cycle time, and 10 minutes for
the Soak time.
The soak time is a minimum
amount. The soak time may be
longer amount depending on the
remaining run times.
NOTE: Before 1 hour, only minutes are
displayed (e.g., 36). At 1 hour or above,
the display will change to include the hour
digit (e.g., 1:13 and 4:00).
Example of Soak screen with
hours included
Station 10 cycle running
39