APRILIA RSV4 Factory Service Station Manual page 376

Suspensions
•
Insert the ring nut, on which the threa-
ded pipe is attached, on the pumping
member pin.
•
Insert the rubber buffer (6).
•
Insert the spring guide support ring (5),
noting the internal milling allowing the
spring guide retainer ring to be instal-
led against the support ring.
•
Insert the spring guide retainer ring (4)
•
Insert the spring guide (3).
•
Insert the spring guide retainer ring (1)
•
Insert the spring guide support ring (2),
noting the internal milling allowing the
spring guide retainer ring to be instal-
led against the support ring.
•
Insert the pumping member pin unit.
•
Use the Öhlins tool to tighten the
pumping member pin fixing ring nut to
40 Nm (29.50 lbf ft).
SUSP - 376
RSV4 Factory