APRILIA RSV4 Factory Service Station Manual page 235

Hide thumbs Also See for RSV4 Factory:

Table of Contents

RSV4 Factory

The height of the swingarm pin relative to the

chassis is adjusted with special inserts installed in

the respective seats in the chassis. The hole is

offset by +2.5 mm (0.098 in) relative to the centre-

line of the insert, as a result the swingarm is in the

high position.

There are 4 inserts, subdivided as follows:

The two right side swingarm pin inserts are differ-

The two left side swingarm pin inserts are the

THE FOUR INSERTS MUST BE FITTED WITH THE ARROW

FACING UPWARDS, OTHERWISE THE VEHICLE WILL BE

THE RIGHT REAR INSERTS (+5mm (+0.19 in)) AND THE LOWER LEFT REAR INSERT (+5mm

(+0.19 in)), ARE EQUAL.

Working from the vehicle left side, in-

stall the left upper engine attachment,

tightening the three screws.

Engine from vehicle

ENG VE - 235