Adjusting The Anti-Scalp Rollers - Toro TITAN ZX4800 Operator's Manual

Transport Lock Position
Adjusting the Height of Cut
The height of cut can be adjusted from 38 to 114 mm
(1-1/2 to 4-1/2 inch) in 6 mm (1/4 inch) increments
by relocating the height-of-cut pin into different hole
locations.
1. Push on the deck-lift pedal with your foot and
raise the mower deck to the transport-lock
position (also the 114 mm (4-1/2 inch) cutting
height position) as shown
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 23).
3. Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (Figure
4. Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (Figure
5. Lower the deck slowly until the lever makes
contact with the pin.
Figure 22
inFigure 23.
23).
22).
1. Deck-lift pedal
2. Handle
g024409
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the flange nut, anti-scalp roller, and bolt
from the bracket
Note:
Keep the bolt and anti-scalp roller
together when removing.
1. Flange nut
2. Spacer
3. Anti-scalp roller
23
Figure 23
3. Height-of-cut positions
4. Pin
EUTRAL
(Figure 24).
Figure 24
4. Bushing
5. Bolt
g024410
-L
OCK
g024312