Servicing The Engine Oil - Toro TITAN ZX4800 Operator's Manual

1. Air-cleaner cover
3. Remove the foam and paper elements
34).
4. Remove the foam element from the paper
element (Figure
1. Air-cleaner cover
2. Foam element
Servicing the Foam Element
1. Wash the foam element in warm water and
detergent.
2. Rinse and allow it to air dry.
3. Lightly oil the foam element with new oil and
squeeze out excess oil.
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
Do not wash the paper element or use
pressurized air, as this will damage the element.
Note:
Replace a dirty, bent, or damaged
element. Handle the new element carefully;
Figure 33
2. Air-cleaner latch
34).
Figure 34
3. Paper element
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
(Figure
3. Install the cover, and secure it with the latches
(Figure

Servicing the Engine Oil

g028105
Oil Type: Detergent oil (API service SJ or higher)
Crankcase Capacity: 1.9 L (64 oz) when the filter
(Figure
is changed
Viscosity: See the table below.
g028106
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
1. Park the machine on a level surface, disengage
the blade-control switch, shut off the engine,
and remove the key.
2. Make sure that the engine is stopped, level, and
is cool, so the oil has time to drain into the sump.
3. Check the engine-oil level
32
34).
33).
Figure 35
the engine-oil level.
(Figure
g017552
36).