Controls - Toro TITAN ZX4800 Operator's Manual

Controls

Become familiar with all the controls before you start
the engine and operate the machine
1. Throttle control
2. Choke
3. Hour meter
Ignition Switch
The ignition switch has 3 positions: S
O .. The key will turn to the S
FF
back to the R position upon release. Turning the
UN
key to the O position shuts off the engine; however,
FF
always remove the key when leaving the machine to
prevent the engine from accidentally starting
5).
Throttle Control
The throttle control is variable between the F
S position. Moving throttle lever forward increases
LOW
engine speed and moving throttle lever to the rear
decreases engine speed. Moving the throttle forward
into the detent is full throttle
Choke
Use the choke to start a cold engine. Pull the choke
knob up to engage it. Push down on the choke knob
to disengage it.
Blade-Control Switch (Power
Takeoff)
The blade-control switch engages and disengages
power to the mower blades
Hour Meter
The hour meter records the number of hours the
blades operate. It operates when the blade-control
(Figure 5).
Figure 5
4. Ignition switch
5. Blade-control switch
(PTO)
, R
TART UN
position and move
TART
(Figure
AST
(Figure 5).
(Figure 5).
switch (PTO) is engaged. Use these times for
scheduling regular maintenance
Fuel Gauge
The fuel window located below the operator position
can be used to verify the level of gasoline in the tank
(Figure 6).
g017722
1. Fuel-gauge window
Motion-Control Levers
The motion-control levers are speed-sensitive controls
, and
of independent-wheel motors. Moving a lever forward
or backward turns the wheel on the same side forward
or in reverse; wheel speed is proportional to the
amount the lever is moved. Move the control levers
outward from the center to the N
and exit the machine
motion-control levers into the N
when you stop the machine or leave it unattended.
Parking-Brake Lever
and
The parking-brake lever is located on left side of the
console (Figure
brake on the drive wheels. Pull the lever up and
rearward to engage the brake. Push the lever forward
and down to disengage the brake.
Foot Pedal Deck-Lift System
The foot pedal deck-lift system allows the operator
to lower and raise the deck from the seated position.
The operator can use the foot pedal to lift the deck
briefly to avoid obstacles or lock the deck in the
highest height of cut or transport position
Height-of-Cut Lever
The height-of-cut lever works with the foot pedal to
lock the deck in a specific cutting height. Only adjust
the height of cut while machine is not moving
4).
14
(Figure
Figure 6
EUTRAL
(Figure 4). Always position the
-L
EUTRAL
4). he brake lever engages a parking
5).
g020264
-L position
OCK
position
OCK
(Figure 4).
(Figure