4.
Lower the mower to the lowest height of cut.
5.
Sit on the seat, start the engine, engage the
blade-control switch, and let the mower run for 1
to 3 minutes.
6.
Disengage the blade-control switch, shut off the
engine, remove the ignition key, and wait for all
moving parts to stop.
7.
Turn the water off and remove the coupling from
the washout fitting.
Note:
If the mower is not clean after one
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
8.
Run the mower again for 1 to 3 minutes to
remove excess water.
WARNING
A broken or missing washout fitting
could expose you and others to thrown
objects or blade contact. Contact with
blade or thrown debris can cause injury
or death.
• Replace broken or missing washout
fitting immediately, before using
mower again.
• Never put your hands or feet under
the mower or through openings in the
mower.
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
50