Removing The Mower - Toro TITAN ZX4800 Operator's Manual

WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
11. Using a spring-removal tool (Toro Part No.
92-5771), install the idler spring over the deck
post and placing tension on the idler pulley and
mower belt (Figure
12. Ensure that the belt is properly seated in all
pulleys.
13. To install the belt covers, insert the tabs on the
each cover into the corresponding slots on the
deck bracket, ensuring that they seat.
14. Rotate the cover to the deck and slide the
notches under the loosened bolts until they are
seated.
15. Tighten the bolts to secure the cover to the deck.

Removing the Mower

Park the machine on a level surface and disengage
the blade-control switch. Move the motion-control
levers outward to the N
the parking brake, shut off the engine, remove the key,
and wait for all moving parts to stop before leaving the
operating position.
Lower the mower to the lowest height of cut. Select
one of the following procedures depending on the
mower deck size installed to complete the removal.
Preparing to Remove the Mower
Deck
1. Lower the mower to the 76 mm (3 inch)
height-of-cut position.
2. Remove the mower belt from the engine pulley;
refer to Replacing the Mower Belt (page
65).
-L position, engage
EUTRAL OCK
Removing the Mower Deck
1. Remove the hairpin cotter and washer securing
the link pin to the frame and deck, and remove
the link bar
1. Link pin
2. Washer
2. Lift up the mower deck to relieve tension from
the mower deck.
3. Remove the chains from the hooks on the
deck-lift arms
46).
1. Deck-lift arm
2. Chain
4. Raise the height of cut to the transport position.
5. Remove the belt from the clutch pulley on the
engine.
6. Slide the mower out from underneath the
machine.
Note:
47
(Figure 66).
Figure 66
3. Hairpin cotter
(Figure 67).
Figure 67
3. Hook
4. Adjustment bolt
Retain all parts for future installation.
g024314
g024313