Table Of Contents - Toro TITAN ZX4800 Operator's Manual

This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
WARNING
Removing standard original equipment parts
and accessories may alter the warranty,
traction, and safety of the machine. Failure to
use original Toro parts could cause serious
injury or death. Making unauthorized changes
to the engine, fuel or venting system, may
violate EPA and CARB regulations.
Replace all parts including, but not limited
to, tires, belts, blades, and fuel system
components with original Toro parts.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory tested by
the engine manufacturer in accordance with SAE
J1995 and rated to J2723.
Do not tamper with the engine controls or alter the
governor speed; doing so may create an unsafe
condition resulting in personal injury.
Figure 2
Contents
Safety ....................................................................... 4
Safe Operating Practices.................................... 4
Toro Riding Mower Safety................................... 6
Slope Indicator ................................................... 7
Safety and Instructional Decals .......................... 8
Product Overview ................................................... 13
g000502
Controls ........................................................... 14
Operation ................................................................ 15
Adding Fuel ...................................................... 15
Think Safety First.............................................. 17
Using the Rollover-Protection System
(ROPS) ......................................................... 17
Understanding the Safety-Interlock
System.......................................................... 18
Testing the Safety-Interlock System.................. 18
Checking the Engine-Oil Level.......................... 18
Breaking in a New Machine .............................. 18
Operating the Parking Brake............................. 18
Operating the Throttle....................................... 19
Operating the Choke......................................... 19
Operating the Ignition Switch ............................ 19
Starting and Stopping the Engine...................... 19
Operating the Blade-Control Switch
(PTO) ............................................................ 20
Driving the Machine .......................................... 21
Stopping the Machine ....................................... 22
Adjusting the Height of Cut ............................... 22
Adjusting the Anti-Scalp Rollers........................ 23
Positioning the Seat.......................................... 24
Adjusting the Motion-Control Levers ................. 24
Pushing the Machine by Hand .......................... 24
Using the Side Discharge ................................. 25
Transporting the Machine ................................. 26
Loading the Machine ........................................ 26
Operating Tips ................................................. 28
Maintenance ........................................................... 29
Recommended Maintenance Schedule(s) ........... 29
Pre-Maintenance Procedures .............................. 30
Service-Interval Chart....................................... 30
Raising the Seat ............................................... 30
Lubrication .......................................................... 31
Greasing the Bearings ...................................... 31
Engine Maintenance ........................................... 31
Servicing the Air Cleaner .................................. 31
Servicing the Engine Oil.................................... 32
Servicing the Spark Plug................................... 34
Cleaning the Blower Housing............................ 35
Fuel System Maintenance ................................... 36
Replacing the Fuel Filter ................................... 37
Electrical System Maintenance ........................... 37
Servicing the Battery......................................... 37
Servicing the Fuses .......................................... 38
Drive System Maintenance .................................. 39
Checking the Tire Pressure............................... 39
Hydraulic System Maintenance ........................... 40
Checking the Hydraulic-Fluid Level................... 40
3